 |
||
 |
Rear frame cross member replacement
The material is 50" of 4"x3"x1/4" angle. A tank support bracket was made from a piece of 1/4x1" flat steel. The ends of the cross member were cut diagonally and a triangle shaped piece was welded to the ends to give the piece a smooth diagonal edge instead of a right angle that would hang up on obstacles. Email me if you have questions. COPYRIGHT © CHRIS C. AND CALL ENTERPRISES 1999-2000 THIS PAGE WAS UPDATED 11/01/2004 This site is about my Jeep. My goal is to help you to better your Jeep through my experience. Thanks for visiting..... Trailhed.com
DISCLAIMER: Any usage or adaptation of any or all of the information provided here or on any or all of my web pages is purely at your own risk. You must take into account your own circumstances and vehicle requirements when attempting to utilize any or all of the information provided on any or all of my web pages. I assume no liability or responsibility for any results, damage, or unforeseen circumstances related in any way to the usage or adaptation of any or all of the aforementioned information. Enjoy |
|
 |
||
 |
||
 |
||
 |
||
| JEEPUNLIMITED BBS VIDEO | ||
